Read Complete Questions & Answers
|
Ask a Question
12/28/2017 – do you have more detailed instructions for sublimating an image on these patches? Thank you in advance
Response From Enmart: That's a great question; we'll have to work something up. Meantime, here are the basics.
First, make sure you have a teflon sheet or cover over your heat press lower platen, especially if you have a heat seal back on the patches. Also, set your heat press to medium-high pressure and 400 degrees F, and 45-65 seconds (the time setting can be changed depending on your particular heat press and the paper you are using; typical is around 50 seconds).
Next, simply cut out your design so that it will fit inside the merrowed border of the patch.
Then, place the patch face up on the teflon, and place the design face down on the patch in the position you want. Repeat for additional patches if you are doing more than one at a time.
Activate your heat press. A minute later, you have sublimated patches!
Take care not to allow the paper to shift on the patches, or you could get ghost images. Some people use a very tiny amount of Sprayway Fast Tack 89 https://store.myenmart.com/sprayway-89-fast-tack-reposition-spray-p866.aspx to hold the paper in place until it is removed. Others may choose to use heat tape https://store.myenmart.com/green-sublimation-heat-tape---72-yd-roll-p3007.aspx.
6/7/2017 – I have been buying patch material from [*******] for years, but someone on facebook recommended you. Please explain to me . . .
Response From Enmart:
Yes, that's precisely what we mean by laminated. Our parent company is Ensign Emblem, and we are one of just a handful of companies that make the patches for the rental uniform and laundry industry in the U.S., and probably the only one that makes almost everything IN the U.S. from U.S. products.
So, all the blank patches and laminated blank patch fabric are exactly the same stuff we make for commercial customers. They have to be tough to hold up in those harsh conditions too, and typically our patches will outlast the garments.
But back to the "laminated" part - basically, the laminated fabric is 4 layers made up of 3 different materials including fabric, the laminate, and a reinforcing material. The laminate is high melt only - you can't use an iron unless maybe you can get one to go up to 400 degrees, but the patches are designed to be put on with a heat press (or sewn on).
If you want to read more about the process of our blank patches (and laminated patch material) this link will give you more info.
3/23/2017 – What is heat seal backing on your blank patches option?
Response From Enmart: Our heat seal backing is a commercial grade film that is designed to be applied with a heat press at 400 degrees F (ideally a label press with small platens and both top and bottom heat) for around 14 seconds at 60 psi.
However - it is also a general purpose backing, and used for stability and finishing, and does not require heat sealing if you just want to sew the patches on instead.
Note that heat seal is not iron on - although, if you don't have a heat press, but have an iron that goes to 400 degrees and you put some weight on it for up to half a minute, some have had success sealing them on that way.
Read Complete Questions & Answers
|
Ask a Question